SOLD - DEALER AD: Pioneer SX-1250 - Completely Redone - recap, alignment, LEDs, etc
Item #649324879Info: Pioneer SX-1250 - Completely Redone - recap, alignment, LEDs, etc
||Cash, Visa, Mastercard, Paypal
Jan 09, 17 12:21pm (PST)
Hudson Valley HiFi
[other classified ads]
8 See details
100% Positive Feedback
HVhifi has a verified PayPal account.Verified in United States
|Days in System:||36|
Sponsored post - log in to remove this ad.
** This Ad is Marked as SOLD by seller and cannot be responded to. **
For sale is a VERY clean Pioneer SX-1250 Stereo Receiver from 1976-1978.
160 watts per channel. Complete rebuild. Fully Functional.
Work done to unit:
-Power Filter caps replaced and upgraded
-Power supply recapped
-Stabilizer board recapped and aligned
-Relay board recapped
-FM board recapped and aligned
-Phono board recapped
-Preamp board recapped
-Tone board recapped
-Power amp boards recapped and adjusted.
(((((all boards were checked completely over... many transistors, diodes, regulators, etc. were also replaced, not just the electrolytic caps))))
-All controls were cleaned and re-lubed.
-All fuse lamps and bulbs were replaced with LED replacements
-Wood case has been refinished with Howard's Restore-A-Finish and Feed N' Wax.
When you go to buy a new receiver, ask yourself these questions:
Does its FM tuner section guarantee high performance of spurious rejection as well as high sensitivity?
Does it include the very latest electronics circuit technology to assure a constant stable and high quality sound reproduction from small to large power output?
Are you going to be proud to own it for a long, long time?
Pioneer's new and elegantly designed SX-1250 AM/FM receiver provides a resounding yes to each of these questions - and then some.
No other Pioneer receiver provides such incomparable FM performance and sensitivity and then combines it with mammoth continuous power output of 160W per channel, min RMS at 8 Ohms, from 20 Hertz to 20,000 Hertz, with no more than 0.1% total harmonic distortion.
Tuning range: FM, MW
Power output: 160 watts per channel into 8Ω (stereo)
Frequency response: 10Hz to 50kHz
Total harmonic distortion: 0.1%
Damping factor: 30
Input sensitivity: 6.5mV (mic), 2.5mV (MM), 150mV (DIN), 150mV (line)
Signal to noise ratio: 75dB (MM), 90dB (line)
Output: 150mV (line), 30mV (DIN), 1V (Pre out)
Speaker load impedance: 4Ω (minimum)
Dimensions: 556 x 186.5 x 464.5mm
This ad was originally posted on US Audio Mart and the seller ships to the United States.
Canuck Audio Mart is FREE!